
FeldsparFX VST____________________________________________________

Copyright  2005 Contralogic Productions
www.contralogic.com

Send feedback/comments to: feedback@contralogic.com


Description______________________________________________________

FeldsparFX is a VST effect plugin based on the ring-modulator,
filters and echo section of the Feldspar VST instrument.

The majority of the panel controls work in the same way as their
counterparts described in the Feldspar manual.  The differences
are explained below:

The envelopes' gate patterns are always active and synced to
host tempo. The "AMP" dial controls how much the output volume is
modulated by Envelope 2.

The RING MOD effect modulates the input with a sine wave, whose
frequency is controlled by the pitch dial.  This can be
controlled by the "Ring.Freq" destination in the modulation
matrix.

The "DRY/WET" dial controls the balance between the effected and
direct input signal.  If you are using FeldsparFX as a send
effect then this control should be set to maximum.


Installation_____________________________________________________

Copy the file FeldsparFX.dll into your VST plugins directory,
FeldsparFX will then be available for use in your VST host.  You
may need to instruct your host software to rescan the VST plugins
folder - please refer to your host's documentation for
instructions on how to do this.


Disclaimer_______________________________________________________

THIS SOFTWARE IS PROVIDED "AS IS" WITHOUT WARRANTIES OF
ANY KIND, EITHER EXPRESSED OR IMPLIED, INCLUDING BUT NOT
LIMITED TO THE IMPLIED WARRANTIES OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PURPOSE.

Contralogic Productions also assumes no responsibility,
and shall not be liable for any such damages to your computer
equipment, software, data or other property on account of
your use of this software.

_________________________________________________________________

FeldsparFX is created with Synthedit (www.synthedit.com)
VST is a trademark of Steinberg Media Technologies AG